Apple III Drivers Aid Cable "C" Device Manufacturer and Models: Diablo 620 Diablo 630 (Use as shown; DO NOT change pin 20!) Diablo 1630 Diablo 1640 Diablo 1650 Xerox 630 (See change; this model ONLY; re: pin 20) Xerox 1710 Xerox 1720 Xerox 1730 Xerox 1741 Xerox 1750 Pin-to-Pin Connections: Apple III (Male) Diablo or Xerox (usually Female) 1 o----------------------------o 1 2 o----------------------------o 3 4 o------------------------+---o 6 +---o 8 6 o----------------------------o 20 (on Xerox 630 ONLY go to pin 11 instead of pin 20) 7 o----------------------------o 7 +---o 4 +---o 5 Wiring Comments: Apple III pin 4 Tie device pins tie to device pins 6 + 8 together 6 + 8 Tie device pins 4 + 5 together; they do not connect to the Apple III Change pin 20 to pin 11 ONLY for the Xerox 630! Note: For proper operation when using the Apple III Super Serial Card (Apple P/N A2B0044) in an Apple III make sure that switch SW 2-6 (on the card) is in the "ON" position and that the jumper block (also on the card) is in the "TERMINAL" Position. Apple III Drivers Aid Cable "D" Device Manufacturer and Model: Texas Instruments 810 Centronics 737 Pin-to-Pin Connections: Apple III (Male) Texas Instruments (usually Female) 1 o----------------------------o 1 2 o----------------------------o 3 4 o------------------------+---o 6 +---o 8 6 o----------------------------o 11 7 o----------------------------o 7 Wiring Comments: Apple III pin 4 Tie device pins tie to device pins 6 + 8 together 6 + 8 Note: For proper operation when using the Apple III Super Serial Card (Apple P/N A2B0044) in an Apple III make sure that switch SW 2-6 (on the card) is in the "ON" position and that the jumper block (also on the card) is in the "TERMINAL" Position. Apple III Drivers Aid Cable "E" Device Manufacturer and Models: Okidata 82A Okidata 83A Pin-to-Pin Connections: Apple III (Male) Okidata (usually Female) 1 o----------------------------o 1 2 o----------------------------o 3 7 o----------------------------o 7 20 o----------------------------o 11 +---o 6 +---o 20 Wiring Comments: Tie device pins 6 + 20 together; they do not connect to the Apple III Note: For proper operation when using the Apple III Super Serial Card (Apple P/N A2B0044) in an Apple III make sure that switch SW 2-6 (on the card) is in the "ON" position and that the jumper block (also on the card) is in the "TERMINAL" Position. Apple III Drivers Aid Cable "F" description on next record.